Hello, I have a sad situation to share -- a friend of mine who is a very good painter, experienced too, fell off a tall ladder that did not have "boots" on it. (I've never seen those.) Anyway, do you think he should have asked for boots before painting? Possibly it was a situation where he was shy to ask because he wanted the job... (I don't know all the details.)
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.

Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Thorough preparation is essential to ensure a good finish. Contractors might have to fill cracks or holes and remove old paint if it is badly worn, peeling or flaking. They remove all paint and apply a suitable primer to the bare surface. If the existing paint is in reasonable condition, they clean it and rub it with abrasive material to provide a key for the new paint. On new surfaces, such as bare wood or fresh plaster, they apply a suitable seal, followed by a primer coat.

House Painting

×