To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
Thanks, all, for your time & efforts adding to the article & comments, especially Dave urging requesting both General Liability AND Worker Compensation insurance certificates to protect from real & fraudulent liability--from my experience especially in California, where insurance fraud is a popular income thief, even causing car collisions to collect.
OF the different type of customers there are at least two: cheap charley's and people who want great results. I agree the need for wall repair is critical to the end results. Most critical is for the customer to be told ahead that the walls are going to need exactly what is needed. This means the contractor must look, touch, examine the walls for defects and needed work. I've been a building manager for 40 years and seen a few paint jobs. Typically a contractor does a lot of talking about how expert he is, but the guys who walk through with note pads, iPads, examine, measure, point things out, explain and recommend are the ones I will deal with. It confirms if they know what the business. Nobody likes the workers to show up and when you talk about the job they're going to do they know nothing but they we were told to be here. Their boss who bid the job doesn't supervise - a big no no around here. Nobody likes surprises or worse, at the end of a job that's not right getting a bunch of little kid excuses. Contractors that do not like the customer to be around looking at the progress don't get the job.
Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.
Thorough preparation is essential to ensure a good finish. Contractors might have to fill cracks or holes and remove old paint if it is badly worn, peeling or flaking. They remove all paint and apply a suitable primer to the bare surface. If the existing paint is in reasonable condition, they clean it and rub it with abrasive material to provide a key for the new paint. On new surfaces, such as bare wood or fresh plaster, they apply a suitable seal, followed by a primer coat.

Interesting information! We just got scammed in White Stone, Virginia... we chose the same color, but went from a flat to an eggshell finish. I wasn't available to stand over the painter while he painted. For such a detailed job, I marveled at how quickly he finished the project! After he was paid for the job, we discovered all he did was roll paint across the walls and close to the crown, baseboards and detailed trim around windows and doors leaving about an inch or so of the flat finish. By using the same color, he didn't even do the job he was paid to do, which explained why he could finish the job so quickly. By using the same color... he got lucky and passed it off as a completed job not bothering to paint to and cut in around the trim. Upon further evaluation of our walls we could see exactly where he stopped because we could see the difference between the flat and eggshell finishes. There are walls he didn't even bother to paint. Then where he did paint near the crown when we were in the room watching ... he hit the crown moulding and tried to tell us it was already there... and tried to sell us on painting the crown moulding. I am so disgusted and upset!! He'll be hearing from us to rectify the situation.


If you are going to hire a contractor (professional painter) give a room by room punch list of the fixing of holes small or big, have it identified for the painter to tell you if you need a drywall finisher or if he does this type of work good. Wall repairs can be 3-5 steps to do repairs ( one per day for good drying of patching material and a good sanding) this is what gives you a good paint job only using high quality paint.
The article was well-intended, but it makes it sound like painters are the crooks and consumers are innocent victims. That is blatantly un-true. Maybe there should be a follow-up article that educates consumers how not to be shysters by expecting a ton more than they said at the start, or not paying the balance of the job unless something else is done that was not in the contract. Tradesmen have a rough road when dealing with consumers that have short arms but long lists of by-the-way items. No, I'm not a painter...

This was very helpful. I wonder if i would really follow through and check to see if my painter was cheating me. I used a painter I found on Angie's List. This was 5 years ago. He did a great job. I know he did patching only for about a day and a half. We decided on the kind of paint before he started. that is what he used. I don't know if I could stay on top of him and watch him open every can of paint.
So why not just paint your own home. I'm not a painter, so my wife and I take our time, buying the paint and supplies, and doing our own painting. Yes, we need to tape, and it's not perfect, but we get the satisfaction of seeing our completed work. Get the supplies, sliders for your furniture, and patience and go for it. That way YOU have control over the entire project.
The cost to paint an average size room (10X12) ranges from $380-$790, not including ceilings, trim or cost of the paint. DIY, this can cost between $200-$300. When estimating the cost, painters will start with how much paint will be required to complete the job. To know this, they first need to know the size of the area to be covered. The easiest way to calculate the size of the paintable area is to add together the length of the wall and multiply it by the width of the room from floor to ceiling. The resulting amount is the room's square footage. This total is a starting point, as it is not all paintable surface. The painters won't paint the windows and doors, for example, and they must account for ceiling trim and baseboards as well. The next step is to subtract the area of the doors and windows -- along with the square footage of the trim and baseboards -- to get an average. Then, use the same calculation (length x width) on the windows, doors, trim and baseboards, and subtract all of those numbers. The result of this equation is the square footage of the room's walls. This is your surface area number. (Painters will typically add a little square footage back in to this amount to account for extra paint, which may be required.)
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.

Load flat or eggshell exterior paint color into paint sprayer. Depending on intensity of hue, apply one or two coats of flat or eggshell exterior paint to entire house. Be sure to work your way from top to bottom in a smooth, controlled manner, overlapping each stroke by 8 inches. TIP: When changing exterior color from light to dark or dark to light, start with a coat of primer to ensure proper coverage. Primer is not necessary when a fresh coat of existing color is being applied.
While we are happy to be recognized for our quality customer service we also realize that if we treat others the way we want to be treated then most if not all of our customers will be pleasantly surprised by using our company as their personal home painters throughout the Denver metro area. We are eager to meet many more of you this coming house painting season too.
As an owners rep and former estimator for a gc i do expect to pay a reasonable deposit say 10 percent and then weekly progress payments. I am asking the painter to book his time and to do the work on my schedule. Most painting companies are not huge operations they will pay their staff weekly. For most repaints i ask for one tinted primer coat and one finish coat for 100 percent coverage. New work gets one tinted primer and two finish coats for 100 percent coverage. The cost of the paint is not really that different for colors or finish. Brands like european fine paint and C2 are more expensive than Ben Moore and sometimes more difficult to roll based on their consistency. Some home depot brands are as expensive as the Ben Moore and of equal quality others aren't. Red paints are notorious for number of coats required and special priming requirements.

When painting the trim, you don’t have to be neat. Just concentrate on getting a smooth finish on the wood. Don’t worry if the trim paint gets onto the walls. You’ll cover it later when painting the walls. Once the trim is completely painted and dry (at least 24 hours), tape it off (using an “easy release” painter’s tape), then paint the ceiling, then the walls.
As a painting contractor I find that most contractors charge between $20 an hour and $45 an hour plus paint and materials pending overhead here in Pennsylvania i figure $30 an hour is a safe bet. figure a good painter should be able to prep a 12 x 12 to a 12 x 15 room, caulk, apply 1 or 2 coats to the ceiling 2 coats on the walls and 1 coat on all baseboards, trim, doors and crown moulding in an 8 to 9 hour day. This is with minimal or minor spackling repairs like nail holes and nail pops, not cracks and peeling tape. Thats extra paint is usually  $30 to $70 a gallon pending quality. A room this size will need 1 gallon for the ceiling 2 for the walls and maybe 1 gallon for the trim, doors ext... the square foot price is $1.50 - $3.00 as far as asking for money up front I never ask. If the home owner buys the paint there is no need for money and if your buying the paint and your an established contractor you have an account with your supplier's.  any ways that's my input and guidelines 
×