This article with comments was terrific - it was so informative. I found the advice useful. It addressed specifics like the condition of the dry wall surfaces, any additional repairs such. pin holes, chalking, smoothing of wall surfaces, absorption of paint and number of coats that may be needed. It should also include insurance coverage, and reflect the clean-up afterwards. Having a written contract with the company's letterhead is a must.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
When requested by the party contracting for renovation services, must use an EPA-recognized test kit or must collect paint chip samples, submit them to an EPA-recognized laboratory, and obtain test results from the laboratory to determine whether components affected by the renovation contain lead-based paint.  Note: you must assume lead-based paint is present for housing and buildings covered by this rule, unless testing is done that determines the components affected are lead-free.

This was very helpful. I wonder if i would really follow through and check to see if my painter was cheating me. I used a painter I found on Angie's List. This was 5 years ago. He did a great job. I know he did patching only for about a day and a half. We decided on the kind of paint before he started. that is what he used. I don't know if I could stay on top of him and watch him open every can of paint.

Painting Contractor Co

×